These are systems which can be connected to a compressed air supply and provide continuous dry air to better than –70 C
Dry Cab BLE1100/77
The Drycab is a vessel to hold printed circuit boards or optical modules whilst purging.
Moisture Trap BLE1100/52
An In-line adsorber used to capture in-built (hygroscopic moisture) returned within an equipment.
Wall Mounting Gas Bottle Holder BLE1100/73
This holds a gas bottle to a bench or wall securely.
Exhaust Line with Flow Regulator BLE1100/70/02
This allows the NEPS1000 to be used for purging small volumes by regulating the exhaust flow.
Oil Vapour Filter BLE1100/58
This is used with the Continuous Dryer, if the air contains oil
Replacement Exchange Dewpoint Sensor BLE1100/56
The NEPS utilises a service exchange dewpoint sensor programme. When the calibration has expired. The user orders a new sensor and returns the old one.
Dewpoint Sensor (new) BLE1100/155
In the event that a sensor cannot be returned, the user must order
a new sensor.
Inter Connecting Tube ( 2 Metres ) BLE1100/55
These are interconnecting tubes, which can be used to purge additional instruments or systems.
The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.